HZ-892A英文說明書介紹

【資料簡(jiǎn)介】

1．Introduction to the

HZ-892A a integrated vibration transducer: the magnetoelectric vibration sensor, precision measuring circuit together, constitute a high precision vibration measuring system, the transmitter can be directly connected to DCS, PLC or other equipment, factory equipment such as fan, motor, water pump is measured vibration ideal choice.

2.Technical parameters

2．1 Frequency response: 10  ~ 1000 Hz

2．2 The natural frequency of vibration: 10 hz

2．3 Range: 0 to 20 mm/s

2.4 Output signal: 4-20mA

2．5Output impedance: Ω 500 or less

2．6Working voltage: DC12-24 v + / - 10%

2. 7Connection mode: two wire

2．7Maximum acceleration: 10 g

2．8Measuring direction: horizontal or vertical or gm,

2．9 Using the environment: the temperature - 40 ℃ ~ 80 ℃ relative humidity of 90% or less

2．10 Dimension: the phi 33 mm x 78 mm

2．11nstall thread: M10 * 1.5* 10 mm (depth)

2．12Weight: about 324 g

3. Installation instructions

3.1 installation location: vertical or horizontal installation on the measured vibration, will be at the bottom of the sensor M10* 1.5* 10 screws on the shell being measured, then the sensor twist on it tight.

3.2 installation size and specification: see figure, if the transmitter installation location by the scour such as steam, to reduce the environmental temperature transmitter, the need to add protective measures, usually without protection.

3.3 wiring instructions: brown wires connect DC24V power supply side, blue wire DC24V power supply the negative side, brown and blue wires at the same time is 4 ~ 20 ma output pin.Wire requirements with good insulation performance, connecting the two core shielded cable.